$0.00
0
0
Subtotal: $0.00
No products in the cart.

How To Install...

Add Storage To Your Attic In Just A Few Easy Steps.

Need help? You can watch our simple step by step installation video, or you can download our comprehensive StoreFloor installation guide.

Step 1

Clear Work Area

You only need clear a small area, by placing items already in the attic to one side. There’s no need to remove items from the attic altogether, as you can build the deck in stages and put items back on to an area you’ve completed. Insulate between the joists if it’s not already been done, but temporarily push aside any insulation that sits over the joists (this will be put back later). Make sure you have all your tools ready – you only need a tape measure, an electric drill and the screws that are supplied with the StoreFloor kits.

Previous slide
Next slide
Previous slide
Next slide

Step 2

Arrange Tri-Supports

Align the Tri-Supports along the joists, avoiding obstacles and spacing them 24″ apart. Screw the supports into the joists through the two pre-drilled holes.

Step 3

Slide On The Steel Beams

Slide the galvanised steel Cross-Beams on to the supports and secure them through the pre-drilled holes and slots. The sliding nature of the Cross-Beams gives you adjustment in case your joists are unevenly-spaced apart. There is no need for the Cross-Beams to meet exactly in the middle.

If you’re going to lay StoreFloor close to the edge of your attic space, then you may not have enough room to slide on the final Cross-Beam. In this case, just assemble the final set of Cross-Beams on to the Tri-Supports (without screwing anything in just yet) before placing the latter on to the joists, then lift them all up as one sub-assembly into place.

Previous slide
Next slide
Previous slide
Next slide

Step 4

Fit The Uni-Supports

Slide the Uni-Supports underneath the Cross-Beams and secure them with a screw through a slot in the top of the Cross-Beam, and another through the hole in the foot of the Uni-Support into the joist. In our kits, we supply one Uni-Support for every second Cross-Beam. Space them out evenly underneath the deck, or in the areas where there will be highest loading or footfall. 

Step 5

Fit The Insulation Above the Joists

Fit the batts, rolls or loose-fill / blown-in insulation between the Cross-Beams, making sure it fits snugly around the supports, without any gaps. 

Previous slide
Next slide
Previous slide
Next slide

Step 6

Secure The Deck

Secure the deck by screwing the flooring boards into the top of the Cross-Beams. The screws self-tap into the metal; there is no need to align the screws with the slots in the top of the Cross-Beams. You don’t need to stagger the boards; the deck is strong enough with them just laid next to each other.

Shop for your Attic!

Whether you’re after complete kits for easy installation, or individual components for custom-sized decks, we’ve got everything you need.

How To Install

Fit your StoreFloor the right way.

Visit our install guide page to get a step by step walkthrough on the installation process of our StoreFloor products.

We are now AtticZone!

Our US site has recently undergone a rebranding from LoftZone to AtticZone, but don’t worry if you’re looking for our UK site, you can still find it at www.loftzone.co.uk.

Take a look at our rebranded site, we’re sure you’ll love it as much as our Attic boarding!